UNITRONICS ERRORS FOR NIKMANN EDGEBANDERS

Errors on NikMann edgebanders with Unitronics Controller

NikMann edgebanders use advanced, integrated technology for streamlined operation. The use of an all-in-one Programmable Logic Controller (PLC) with an HMI panel makes them user-friendly and efficient, especially with the Vision system programmed using VisiLogic.

VisiLogic's combination of Ladder Logic, HMI design, and communication setup in one interface is a powerful tool for optimizing machine functionality.

For more information, please call: 1300 4 FORZA

Unitronic controller

ALARM: 00

Emergency stop - ON.

Release emergency stops.

ALARM: 01

Overloading frequency inverter. Possible overheating on one of the frequency motors.

- Turn OFF the machine main power switch.

- Wait about 30 seconds.

- Turn ON the machine.

ALARM: 02

Any of the induction motors is overheated.

- Wait until the overheated motor cools down to normal working temperature.

ALARM: 03

The door of machine is open.

- Close the door.

ALARM: 04

The compressed air system pressure is lower than 0.5 MPa.

- Provide normal working pressure of 0.6 MPa.

ALARM: 05

Second work piece is fed before the enabling signal by the light indicator lamp at the machine inlet.

- Remove both work pieces and then switch the machine off using the main switch and wait for approximately 20 seconds and then switch the machine on again.

ALARM: 06

In the initial initialization rounding unit is not detected by any sensors.

- To be removed alarm is necessary unit to be initialized manually (by manually movements it).

- Manual initialization can be done in the air off.

ALARM: 06

Rounding unit has failed to crawl detail timely and has reached the end of the horizontal move.

- It is the part to be removed manually from the feed. The alarm will automatically disappear 30 seconds after its appearance.

ALARM: 07

The capacitive sensor B1 is not included.

- Check that the sensor works.

- Turn on the machine and press the Emergency Stop.

- Place your finger on the sensor, if OK LED on the sensor should light.

- Once you remove your finger should go off.

- The distance between the work piece and the sensor B1 is very large.

- Adjust the distance between the work piece and the sensor about 1 mm

PHASE ALARM

Poor quality of the supply voltage (too low, too high or asymmetry phase).

- Check that there is no break or loose connection in the power supply.

- The machine cannot be powered properly, R S T the phases are reversed.

WOODWORKING MACHINERY SERVICE

From emergency repairs to scheduled maintenance, sourcing spare parts or specifying a new woodworking machine - call 1300-436-792 for our expert advice and support.

SERVICE